Ovulation Test 

1. Open the pouch shortly before testing and remove the test device.
2. Pull out the cap and expose the absorbent tip to urine for at least 5 seconds. The sample can also be tested in a clean, dry container. To do this there has to be enough urine in the container to put the absorbent tip completely into the urine for 5 seconds.
3. Re-cap the device for hygienic reasons and place the test device on a flat surface. Make sure the window side is up. Wait until the pink lines show up. Read the result after 3 to 10 minutes. Please note!: Do not read results after more than 10 minutes.

• Do not carry out the tests with the initial morning urine as the concentration may be too high and this may distort the result.
• LH concentrations vary from one person to the next and from one cycle to the next. Tip: You will achieve the best results if you carry out each test at the same time of day.
• Try to drink less than usual 2 hours before carrying out the test as otherwise the hormone levels in the urine may be diluted and this may distort the result.

• Passing the urine over the absorbent tip (e.g. in a cup) may cause malfunction of the test.
• Do not read results after more than 10 minutes. 
• Insufficient specimen volume or incorrect procedural techniques are the most likely reasons for control line failure. Review the procedure and repeat the test with a new test. If the problem persists, please contact your pharmacy.

Keep away from direct sunlight and store in a dry place at a temperature between 2°C and 30°C.

• 5x tests
• 1x instruction leaflet